How do I use an insulin pen?
Select a clean, dry work area. The supplies you will need include:
- The prescribed insulin pen
- Pen needles and alcohol wipes
- A container for used equipment. You can use a hard plastic container with a screw-on or tight lid, or a commercial “sharps” container.
Here are the steps you will take:
- Begin by washing your hands.
- Remove the cap of the insulin pen.
- If the insulin in the pen appears cloudy, roll the pen in your hands and turn it from side to side for one full minute. You do not have to roll the pen if the insulin is completely clear. Do not shake the pen.
- Wipe the rubber stopper with an alcohol wipe.
- Attach a new pen needle onto the insulin pen. Pen needles come in different sizes. Talk to your healthcare provider to choose the pen needle that is best for you.
- To attach the pen needle, pull the paper tab off the pen needle, screw the new needle onto the pen, and remove the outer cap of the needle. You will need the outer cap to remove the needle from the pen when you are done with the injection. Remove the inner cap.
- Prime the insulin pen. Priming means removing air bubbles from the needle, and ensures that the needle is open and working. The pen must be primed before each injection.
- To prime the insulin pen, turn the dosage knob to the 2 units indicator. With the pen pointing upward, push the knob all the way. At least one drop of insulin should appear. You may need to repeat this step until a drop appears.
- Select the dose of insulin that has been prescribed for you by turning the dosage knob.
- Check that the dose is correct. Set the pen down without letting the needle touch anything.
Where on the body do I inject with the insulin pen?
Recommended injection sites include the abdomen, front and side of the thighs, upper and outer arms and buttocks. Do not inject near joints, the groin area, the navel, the middle of the abdomen, or scar tissue.
You will also need to rotate, or switch, your injection sites. If you use the same injection site over and over again, you may develop hardened areas under your skin that keep the insulin from working properly. Rotating your injection sites will make your injections easier, safer and more comfortable.
Follow these guidelines:
- Ask your healthcare provider which sites on your body you should use for injections.
- The injection site is about two inches of skin. Clean this area with an alcohol wipe in a circular motion.
- Move the site of each injection. Inject at least one-and-a-half inches away from the last spot where you injected.
- Try to inject in the same general area of your body at the same time each day.
- Keep a record of which injection sites you have used. Every time you give yourself an injection, write down the date, time and site.
Depending on which type of insulin you are taking, different parts of the body may absorb the insulin differently.
Injecting insulin with an insulin pen:
- Using the hand you write with, wrap your fingers around the insulin pen, keeping your thumb free to push down on the knob.
- Insert the needle with a quick motion into the skin at a 90-degree angle. The needle should go all the way into your skin.
- Slowly push the knob of the pen all the way in to deliver your full dose. Remember to hold the pen at the site for 6-10 seconds, and then pull the needle out.
- You may bleed at the spot of the injection. If you notice bleeding, apply pressure with a clean alcohol wipe or cotton ball. Cover the injection site with a bandage if necessary.
- Carefully place the outer cap on the needle, unscrew the needle (the needle should come off with the outer cap) and drop into your container for used “sharps” equipment.
- Replace the pen cap and store it at room temperature.